Sonos Ace button controls

This button is used to power your Sonos Ace on or off as well as put it into Bluetooth pairing mode.

• Long press - Power Sonos Ace on or off. Release the button when the status light turns on or off, or when you hear the headphones play a power on / power off tone.
• Press and continue holding - Put Sonos Ace into Bluetooth pairing mode. Release the button when the status light begins flashing blue. If already powered on, Sonos Ace will first power off and then power on again before entering pairing mode.
• Press and hold for 10 seconds - Perform a forced reboot.

The Content Key is used to adjust volume, skip songs, and answer phone calls.

If you’ve set up TV Audio Swap with your Sonos Ace, you can also use the Content Key to quickly swap TV audio to your headphones.

Audio controls

• Slide up or down - Adjust the volume.
• Press once - Play or pause.
• Press twice - Skip the current song.
• Press three times - Play the previous song.

Phone controls

• Press once - Answer or end your current call.
• Long press - Decline an incoming call.

TV Audio Swap

• Long press - Swap audio from your home theater speaker to your Sonos Ace, or swap back.

This button is used to switch Noise Control modes as well as trigger your Bluetooth device’s voice assistant, if available.

• Press - Cycle through your selected Noise Control modes. By default, this will go back and forth between Aware Mode and Noise Canceling.
• Press and hold - Activate your Bluetooth device’s voice assistant, if available.